AERIS Bubbler — How to Use

The AERIS Bubbler adds water filtration to your AERIS for cooler, smoother hits. Setup takes under two minutes — here's everything you need to know.

What you'll need

• AERIS base unit (powered off)
• AERIS Bubbler
• Magnetic Bubbler Adapter Ring
• Clean water
• Dab tool and concentrate
• Dab swab for post-session cleanup

Step-by-step setup

1. 1
   Power off and remove the mouthpiece

   Press the V button 5 times to power off the AERIS. Remove the silicone mouthpiece from the top of the device — the Bubbler attaches here in its place.

2. 2
   Attach the Adapter Ring to the Bubbler

   Take the magnetic Bubbler Adapter Ring and insert it snugly into the base of the Bubbler. Press firmly until it seats — you'll feel it lock in. This is what connects the Bubbler to the AERIS magnetically.

3. 3
   Fill to the correct water level

   Fill the Bubbler with clean water up to just below the top of the small triangle marker on the back-bottom of the Bubbler. That's the sweet spot — enough for full filtration without water splashing into the atomizer. Less water = lighter filtration and less drag.

4. 4
   Attach the Bubbler to the AERIS

   Lower the Bubbler onto the top of the AERIS base. The magnetic adapter will click into place automatically — you'll hear and feel it seat. Give it a gentle tug to confirm it's locked on.

5. 5
   Load your concentrate

   Pull the Swivel cap straight up and off to open the atomizer. Load a rice-grain size dab onto the Intelli-Core insert using a dab tool. Avoid touching the sides of the ceramic cup. Place the Swivel cap back on to close.

6. 6
   Start your session

   Power on the AERIS (V button × 5), select your preset, then double-click V to start heating. When the LED signals ready, inhale slowly through the Bubbler mouthpiece.

7. 7
   Use the Swivel during your session

   The Swivel cap can be removed during your session to adjust airflow. Pull it off for a more open draw, or keep it on for a restricted, water-filtered hit. Try both and see what you prefer.

8. 8
   Clean up after each session

   Use a Dab Swab to remove any remaining concentrate from the atomizer cup immediately after your session while it's still warm. This prevents buildup that causes error codes and shortens atomizer life.

Tips for better sessions

• Sip, don't rip — slow draws through water filtration produce denser, cooler vapor than hard pulls
• Cold water gives the smoothest hits; warm water produces slightly more vapor
• Change the water every 3–5 sessions — stale water affects flavor
• If water is splashing into your mouth, you've overfilled — pour a little out until it sits below the triangle
• The Bubbler is dishwasher safe on the top rack (remove the Adapter Ring first)