INTELLI-CORE & Everlast — Care Guide

Taking proper care of your atomizer is essential for preserving flavor and performance. This guide covers maintenance for both the Intelli-Core and Everlast atomizers for oil concentrates.

Intelli-Core

1. 1
   Swab after every dab

   After each session, use a cotton swab to clean the insert of the atomizer. This removes residual concentrate and prevents chazzing (burnt residue buildup) that degrades flavor over time.

2. 2
   Avoid overloading

   Use an appropriate amount of concentrate. Overloading causes leaks into the atomizer casing, which leads to continuous burning of residue and tainted flavor. Load conservatively for best results.

3. 3
   Periodic deep clean (every 25–50 dabs)

   Remove the atomizer from the base. Remove any silicone accessories. Soak the atomizer in 70–90% isopropyl alcohol for 5–10 minutes. Pat dry and air dry for at least 1–2 hours before reinstalling. Use an isopropyl-dampened swab to clean the base port while the atomizer dries.

4. 4
   Warm before removing

   If the atomizer feels stuck, run a 15-second session at the lowest temperature to soften any wax buildup at the connection. Power off and let cool before unscrewing counterclockwise.

Everlast (discontinued — still supported)

The Everlast atomizer has been discontinued but is still fully supported. The care and cleaning process is identical to the Intelli-Core.

1. 1
   Swab after every dab

   Clean the insert with a cotton swab after each session to remove residual concentrate and prevent buildup.

2. 2
   Periodic iso soak (every 25–50 dabs)

   Soak the atomizer in 70–90% isopropyl alcohol for 5–10 minutes. Remove silicone accessories before soaking. Air dry fully (1–2 hours) before reinstalling.

3. 3
   Warm before removing if stuck

   Run a short low-temperature session to loosen any wax at the connection before unscrewing.